Die Casting Blog for Cast-Parts Aluminum Die Cast Parts and Zinc Die Cast Parts manufacturing and cast parts production

November 2, 2013

Technical Issues Regarding Die Cast Parts and Its Uses

Technical Issues Regarding Die Cast Parts and Its Uses. Die Castings are just similar in nature with permanent mold casting, with the exception of the metal under high pressure (10-210 MPA) injected directly into the tool. The result would be a more uniform part, clean surface finishes complete with excellent dimensional accuracy, as better as 0.2% in precise die casting dimensions. For the other die casting parts, manufacturers wouldn’t have to worry about post-machining anymore, since the whole procedure can now do without it.

The die casting production process is accomplished using either the cold or hot chamber die casting process. The cold chamber die casting process is characterized by directly ladling melted metal into the mold for each shot. Here, there is considerably less exposure time of the melt making contact with the plunger walls, which comes in handy for important metals (aluminum, copper and all of their die casting alloys) that would alloy with iron easily in high temperatures.

A hot chamber casting procedure on the other hand requires the pressure chamber to be connected directly to the tool cavity. This should make for a permanent immersion of the molten material used in the process. The pressurizing cylinder’s inlet port would be uncovered for the plunger to move into open space freely. This development allows new molten die casting metal charge to fill up the die cavity much faster than that of the cold chamber die casting process. This method is mainly used for those die casting metals with low melting points and higher fluidity characteristics (zinc, tin, and lead).

Casting molds are costly since they are made entirely from hardened steel, with the exemption of harder and stronger metals that cannot be die cast (steel, iron). Another factor would be the relatively long cycle periods needed in building these casting mold types.

Common metals utilized in the die casting process include aluminum, copper alloys and zinc. Pure aluminum on the other hand is used rarely because of its high shrinkage characteristic and vulnerability to hot cracking. It is alloyed instead with silicone, making for increased melt fluidity, significantly reducing its machine ability. Copper is another important element that increases hardness when alloyed. It has the ability to reduce ductility and corrosion resistance. Copper alloys are important components in marine and electrical applications where wear and rusting plays a fundamental role in the process.

Die casting processes using magnesium are limited at 20 kg max, and up to 35 kg max for zinc. Large casting operations normally suffer from greater porosity problems, most probably due to entrapped air that initiates the solidifying of the melt even before it gets a chance to extend to the edges of the die casting die cavity. Manufacturers get side step this through vacuum die casting.

From a design efficiency angle, it would be smart to conceptualize die casting parts with uniformed breadth on the walls and its cores of uncomplicated designs. The heavy sections of die castings bring up some severe cooling problems, with trapped gasses wreaking havoc with the die casting part and causing porosity. Manufacturers at www.castings-aluminum.com must see to it that all corners be radii with extra space just to avoid stress concentration.

Cast-Parts Die Castings Blog gives information on how to get a Aluminum and Zinc Die Castings. If you are looking for Die Casting Parts look at this website.

Follow on Twitter
Follow Us On Twitter

Cast Parts Company Die Casting Company
6918 Beck Avenue
North Hollywood, CA. 91605
818-982-9386 Phone
Sales@Cast-Parts.com.

No Comments

No comments yet.

RSS feed for comments on this post.

Sorry, the comment form is closed at this time.

Powered by WordPress